COREv2 Air-Sea Surface Fluxes
The Coordinated Ocean Research Experiments version 2 (COREv2) data set consists of a globally complete set of air-sea fluxes of momentum, heat and freshwater for 1948-2009 at monthly resolution. This data set serves as a set of common atmospheric boundary conditions that has been used by the ocean modeling community to force and compare a diverse set of coupled ocean-sea ice models. The primary data source is the NCEP/NCAR R1 reanalysis product. To reduce climatological biases in COREv2, the main NCEP/NCAR R1 fields used to compute the turbulent air-sea fluxes have been bias corrected on the basis of comparison with more reliable satellite and in-situ data. Satellite-based radiation data and blended satellite-gauge precipitation data are used in place of the reanalysis data for 1984-2009 and 1979-2009, respectively. Prior to the satellite era, COREv2 does not contain realistic time-varying radiation and precipitation fluxes. Another disadvantage of COREv2 is that there are no estimates of uncertainties.
Contains a globally complete set of air-sea momentum, heat and freshwater fluxes for 1948-2009 at monthly resolution
COREv2 boundary conditions yield a small, globally averaged heat imbalance of 1.6 W/m^2 when coupled to observed SSTs, allowing for long model integrations with minimal ocean drift
Source data from the NCEP/NCAR R1 (near surface wind, potential temperature, specific humidity, and density) were bias adjusted to reduce climatological biases
Lack of realistic variability in the precipitation and radiation fluxes prior to the satellite era
No uncertainty estimates
Expert User Guidance
Expert Developer Guidance
The following was contributed by Dr. Stephen Yeager, November, 2015:
This data set constitutes a complete set of global air-sea heat and freshwater flux components from 1948 through 2009 at monthly resolution. The atmospheric data set used is a combination of state fields from atmospheric reanalysis and satellite-derived flux measurements that is referred to as "COREv2"--Coordinated Ocean-ice Reference Experiments data set, version 2 (Large and Yeager 2009, hereafter LY09). COREs are coordinated model intercomparison efforts undertaken by the international ocean and sea ice modelling communities in which a diverse set of coupled ocean--sea-ice models are forced with common atmospheric boundary conditions (Griffies et al. 2009). The COREv2 atmospheric data set documented in LY09 is based primarily on surface fields from the NCEP/NCAR R1 reanalysis product (referred to hereafter as NCEP) that are available from 1948 to present, but it incorporates satellite and in situ measurements to either adjust or replace certain NCEP fields deemed unreliable. As documented in Large and Yeager (2004) and later in LY09, a key motivation for generating the COREv2 atmospheric data set is to provide a full suite of best-available, historical boundary conditions for ocean and sea-ice modelling studies. The COREv2 data set has been promoted and disseminated by the CLIVAR Ocean Model Development Panel (http://www.clivar.org/clivar-panels/omdp/core) for coordinated studies (e.g., Danabasoglu et al. 2014) that are collected in a virtual special issue of the journal Ocean Modelling (http://www.journals.elsevier.com/ocean-modelling/news/core-ii-virtual-special-issue/). The COREv2 data and release notes can be downloaded from a server at the NOAA Geophysical Fluid Dynamics Laboratory (GFDL; http://data1.gfdl.noaa.gov/nomads/forms/core/COREv2.html).
In COREv2, NCEP surface radiation is replaced with daily surface downwelling longwave and shortwave radiative fluxes from the GISS ISCCP-FD data set (Zhang et al. 2004) that spans 1984-2009. NCEP precipitation is discarded in favor of a blended product (spanning 1979-2009) that combines GPCP (Global Precipitation Climatology Project; http://precip.gsfc.nasa.gov/), CMAP (Climate Prediction Center Merged Analysis of Precipitation; http://www.esrl.noaa.gov/psd/data/gridded/data.cmap.html), and monthly climatology over the Arctic (see LY09 for details). Other atmospheric state fields required for computing turbulent air-sea fluxes (i.e., near surface wind, potential temperature, specific humidity, and density) come from NCEP, but with adjustments applied to reduce climatological biases. The biases (and corresponding adjustments) are determined by comparing with more reliable satellite or in situ measurements that themselves are too regional or short in duration to serve as forcing data for historical ocean--sea-ice simulations. As implied above, not all of the data streams in COREv2 are available over the full 1948-2009 time period; climatological fill is used to fill in missing years (see LY09 for details). The COREv2 release notes also describe the historical continental freshwater discharge data set (based on Dai et al. 2009) that is incorporated as an ocean forcing field. Although not strictly an air-sea flux, this runoff flux is included in the COREv2 flux data set for completeness.
While COREv2 was developed for the purpose of forcing prognostic ocean and sea ice models, it can alternatively be "coupled" to observed, historical ocean and sea ice fields through bulk formulae to yield an estimation of historical air-sea fluxes. That is the procedure used to generate this COREv2 flux data set.
Turbulent air-sea fluxes (evaporation, sensible and latent heat fluxes, and wind stress) are obtained by coupling the COREv2 atmospheric data stream with monthly observed sea surface temperature (Hurrell et al. 2008) using the standard bulk formulae of the Community Earth System Model (CESM; see LY09). These turbulent fluxes are computed at 6-hourly temporal resolution (using linear interpolation of the monthly observed SST field), and then time-averaged to yield monthly-mean fluxes. Daily fractional sea-ice concentration from satellite measurements from the National Snow and Ice Data Center (NSIDC) are used to mask the air-sea fluxes in polar regions. Together with the radiation and precipitation fluxes, these constitute a complete set of historical air-sea fluxes.
From the perspective of ocean modelling, a key advantage of the COREv2 boundary conditions is that, when coupled to observed SST as outlined above, they yield a globally-averaged, climatological (1984-2006) air-sea heat flux of only 1.6 W/m^2. This relatively small heat imbalance, which LY09 argue is largely consistent with available estimates of long-term ocean warming, allows for long integrations over multiple forcing cycles with minimal ocean drift (assuming the model is capable of accurate simulation of observed SST and sea ice). The widespread use of COREv2 in the ocean modelling community makes this a natural companion flux data set to use for evaluating model fluxes. The fidelity of COREv2 fluxes cannot easily be ascertained, but LY09 show that they imply oceanic heat and freshwater transports that are compatible with direct observations and they compare favorably with other air-sea flux products (see Valdivieso et al. 2015). On obvious disadvantage of COREv2 fluxes is the lack of realistically varying precipitation and radiation fluxes prior to the satellite era. COREv2 will probably exhibit less agreement with in situ buoy measurements than products like OAFlux (Yu and Weller, 2007) that use these data in a more systematic way to constrain fluxes. Finally, another drawback of the COREv2 flux data set is the lack of error estimates, because these are likely to be substantial. Flux comparison papers like Valdivieso et al. (2015) give a sense of the uncertainties inherent to air-sea flux estimation.
Cite this page
Acknowledgement of any material taken from or knowledge gained from this page is appreciated:
Yeager, Stephen & National Center for Atmospheric Research Staff (Eds). Last modified "The Climate Data Guide: COREv2 Air-Sea Surface Fluxes.” Retrieved from https://climatedataguide.ucar.edu/climate-data/corev2-air-sea-surface-fluxes on 2024-02-24.
Citation of datasets is separate and should be done according to the data providers' instructions. If known to us, data citation instructions are given in the Data Access section, above.
Acknowledgement of the Climate Data Guide project is also appreciated:
Schneider, D. P., C. Deser, J. Fasullo, and K. E. Trenberth, 2013: Climate Data Guide Spurs Discovery and Understanding. Eos Trans. AGU, 94, 121–122, https://doi.org/10.1002/2013eo130001
- Large, W., Yeager, S., 2009: The global climatology of an interannually varying air-sea flux data set.Clim. Dynamics
- Dai et al., 2009: Changes in continental freshwater discharge from 1948 to 2004, J. Climate, 22, 2773-2792, doi:10.1175/2008JCLI2592.1
- Danabasoglu et al., 2014: North Atlantic simulations in Coordinated Ocean-ice Reference Experiments phase II (CORE-II). Part I: Mean states, Ocean Modelling, 73, 76-107, doi:10.1016/j.ocemod.2013.10.005.
- Griffies et al., 2009: Coordinated Ocean-ice Reference Experiments (COREs), Ocean Modelling, 26, 1-46, doi:10.1016/j.ocemod.2008.08.007.
- Hurrell et al., 2008: A new sea surface temperature and sea ice boundary dataset for the Community Atmosphere Model, J. Climate, 21, 5145-5153, doi:10.1175/2008JCLI2292.1.
- Large and Yeager, 2004: Diurnal to decadal global forcing for ocean and sea-ice models: the data sets and climatologies. Technical Report TN-460+STR, NCAR, 105pp.
- Valdivieso et al., 2015: An Assessment of air-sea heat fluxes from ocean and coupled reanalyses, Clim. Dyn., doi:10.1007/s00382-015-2843-3.
- Yu and Weller, 2007, Objectively Analyzed Air-Sea Heat Fluxes for the Global Ice-Free Oceans (1981-2005), BAMS, 527-539, doi:10.1175/BAMS-88-4-527.
- Zhang et al., 2004: Calculation of radiative flux profiles from the surface to top-of-atmosphere based on ISCCP and other global data sets: refinements of the radiative transfer model and input data, J. Geophys. Res., 109, doi:10.1029/2003JD004457.